Industrial Pre-Woven


Industrial Pre-Woven is a uniquely styled slat that is mechanically inserted into the chain link wire during the weaving process. Once inserted, the wire is finished above and below the slat (either bow-knuckle or knuckle-over).

Design: Industrial pre-woven slats are flat and tubular in shape, with reinforced “legs” inside for extra durability.

Standard Heights: 4, 5, 6, 7, 8,10 and 12 feet. Special heights available upon request.

Wind Load and Privacy Factor: Approximately 75%.

Upon Special Request: Available in bags that cover 25 linear feet for hand installation jobs.

Installation: Because this slat comes pre-inserted in the chain link fabric, just stretch the wire and tie it up. The result is a fully slatted fence with sight reduction.

Warranty: 25 years prorated.

Product PDF – Industrial Pre-Woven

Slat Type Slat Width Mesh Size Wire Gauge Slats Per Crate Coverage Per Crate
Industrial 2 3/8″ 3 1/2″ x 5″ 9 or 10 2014 (106 pieces per bag) 475 linear feet

Available Colors

royal_blue light_blueredwoodgreen    brownbeige black  graywhite

Royal Blue – Light Blue – Redwood – Green – Brown – Beige – Black – Gray – White

HDPE Technical Properties
Melt Index – (.6) A low melt index indicates improved stress and crack resistance.
Density – (.957) Polyethylene ranges anywhere from .914 to .960 in density. A higher density yields maximum stiffness without becoming overly brittle.
Minimum Temperature – (-76° F) Polyethylene stays flexible even at this temperature extreme.
Maximum Temperature – (250°) Polyethylene does not distort until reaching this temperature.
Tensile Strength – (3,700 psi) Material will not suffer distortion at letter loads or impacts.